Long story short: I could not get the command asterisk -rx “module load codec_g729a.so” to work. It would say “Unable to load module codec_g729a.so” So in my assumption that the instructions for loading this bugger is correct, was wrong. There are modifications you need to make for the instructions if you are on a 64 bit distro, as opposed to the assumption in some of the commands in the readme that assume you are on 32 bit. What I had to modify, was to copy the codec_g729a.so module to: /usr/lib64/asterisk/modules/ instead of /usr/lib/asterisk/modules/ Now that it was in the right place, I could use the asterisk -rx “module load codec_g729.so” command with success. All of the g729 commands now work. It seems again, that a lot of assumptions are made in documentation for Asterisk as well as FreePBX. Try, and try again. Re-read the instructions, assume they are right until you try everything, thing start poking around again, try again. Frustrating, but at least I got it! G711 Vs G729 BandwidthOriginal post: In the Admin, Digium Addons part of FreePBX, there is a listing for the Addon “G.729 Codec”. Additionally, there are links for Purchase, Install/Uninstall, Add-License, Backup and Documentation. This gives me the impression that all of the provisioning can be handled by the GUI. Virtual pool 4 review. What I have done so far, clicked on the link for Purchased, and gotten 4 g729 licenses with the key sent to me by email from Digium. Next, I clicked on the link for Install, and it installed the codec (or at least I thought it did, after all, it now says Uninstall, as before it said Install). How To Install Video CodecsLastly, I clicked on the Add-License and added all of the information, Name, license key, etc. Then I made sure my Flowroute trunk has: username=xxxxxxxxxxx type=friend secret=xxxxxxxx insecure=port,invite dtmfmode=rfc2833 context=from-trunk canreinvite=no allow=ulaw&g729 I went to my extensions, and have g729 in the Allowed Codec section (I am not allowing ulaw yet unitl I am able to test g729 fully) I placed a call from my extention to my cell phone, then I used the Reports, Channels to see that it indicates it is using g729. It looks good, as it says (g729) in the format column for the extension and the flowroute peer. Not to hijack the thread, but licensing has already expired on g729 codec, you should not need to buy a license for it. If you google around, you will find out how. Super ovladac klic. What I had read is that while the patents on G.729 have expired, you still have to pay the people who implemented and possibly optimized it. Jun 7, 2018 - mod_com_g729 allows you to have the G.729/A audio codec in FreeSWITCH. This will install the module and supporting software to /usr/local/freeswitch. Warning: This means that if these MAC addresses change, the. How To Install G729 Codec In Switch Windows 10Now here is where I am confused or not sure I have this working right. When I go to the CLI, I use: g729 show licenses and it says 'No such command ‘g729 show licenses’ So, I am assuming that I still have to follow the specific instructions from digium to get this thing rolling? Or can all of that be done through the GUI. The GUI part just screams “I can do this for you” but I suspect that is not the case. Your assistance is appreciated.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |